Introduction

Features

• Bluetooth

  For ease of connectivity it has a Bluetooth input. The device name and pin are fixed and cannot be changed. It can only pair with one device at a time.

  A device can be manually unpaired by pressing the INPUT 3 dial. If you do not want Bluetooth active just set input 3 to mic input with the switch on the rear.

• Mixer Amp

  This amp has four inputs, each of which can either be used for a microphone or a line-level input. It is a true mixer amp, so it can bring together multiple sources and play them at the same time.

• Mic Pre-Amp Trim

  The input gain for each mic input can be "trimmed" - adjusted on the rear panel. This allows the installer to "turn up" less sensitive mics, and "turn down" hot inputs.

• Switchable Phantom Power

  Each mic input has Phantom power which is a voltage required to make professional condenser mics work. Phantom can be turned off on each input discretely.

• Four Microphone Inputs

  All mic inputs are “balanced” to eliminate electro-magnetic noise induced on long cables. Input 1 uses a professional XLR connector - more convenient for rental and portable use, and the other inputs use phoenix connectors - more suited to permanent installations.

• RS-232

  Designed for integration with a bigger system, it can be controlled by a control system such as Techconnect Control via RS-232.

• D-Class

  An efficient Digital-class amplifier chip dramatically reduces power consumption especially at rest, and makes this amp super-small.

• 3 x Stereo Inputs

  Three line-level stereo inputs accept input from a variety of sources such as computers (via the headphone jack), tablets or phones. Inputs 1 and 2 use 2-phono (RCA) connectors. Input 4 is via a Minijack connector, and is duplicated on the front panel for adhoc access.

• Line Output

  A line-level pre-output on the rear bypasses the internal amplifier. It would connect to a larger amplifier or powered loudspeakers. It is post-mix; volume adjustments made on the front panel affects the output level.

• Auto-Standby

  If the amplifier senses no input it will automatically go into standby mode. When it senses input it will reactivate. Auto-standby can be disabled via RS-232.

• Mounting Options

  Rack ears are included so it can be integrated into an AV rack.

• 8 or 4 Ohms

  The powerful amp can drive a 8 ohm load (two loudspeakers), or 4 ohm load (four loudspeakers).