2 x 25w Digital Amplifier
2 x 25w RMS (at 8 ohms) low impedance digital power amplifier
3 x Stereo inputs / 1 x Stereo Pre-Output / 1 x Balanced Mic input with Phantom Power
IR remote included, RS-232 control
The improved AV-1800 is compact, and has a simple interface with just two dials which are turned to adjust and pushed to switch. It has a selection of inputs – including Bluetooth and a microphone input, making it suitable for meeting rooms, small auditoriums, lecture theatres, school halls, and small churches.
The amplifier can automatically switch to the Bluetooth source when it is paired. Bluetooth can be renamed and the pin changed by connecting to a PC (see software link below).
It uses a professional XLR connector and the input is “balanced” to eliminate electro-magnetic noise induced on long cables. The microphone input has “Phantom Power” – a voltage which is required by condenser-type microphones such as lectern microphones.
It can be controlled by a control device such as Techconnect Control via IR or RS-232. It also comes with an IR remote control gives the user bass and treble adjustment and direct input selection.
An efficient Digital-class amplifier chip dramatically reduces power consumption especially at rest.
3 x Stereo Inputs
Three stereo inputs accept input from a variety of sources such as computers (via the headphone jack), tablets or phones. 2 of the inputs are via 2-phono (RCA) connectors on the rear panel. Input 3 is via a 3.5mm Minijack connector, and is duplicated on the front and rear panels for easy access.
A line-level pre-output on the rear panel bypasses the internal amplifier. It would connect to a larger amplifier or powered loudspeakers. It is post-mix, which means any volume adjustment made on the front panel affects the output level.
If the amplifier senses no input it will automatically go into standby mode. When it senses input it will reactivate. Auto-standby can be disabled.
Optional mounting hardware is included to allow cable-tying either to a projector ceiling pole, or into a rack.
- AMPLIFIER DIMENSIONS
- 253 x 253 x 45 mm / 9.96″ x 9.96″ x 1.77″ (wide x deep x tall) not including dials and connectors
- CARTON DIMENSIONS
- 415 x 230 x 80 mm / 16.34″ x 9.06″ x 3.15″
- AMPLIFIER WEIGHT
- 2.0 kg / 4.4 lb
- PACKAGED WEIGHT
- 2.4 kg / 5.3 lb
- 3 x Stereo inputs via 2-phono (RCA) connectors / 1 x 3.5mm (1/4″) minijack
1 x Bluetooth input
1 x Microphone inputs via balanced XLR
- 1 x Stereo Line-level output via phono connectors (post mix)
- 2 X 25W @ 8 OHMS
- TOTAL HARMONIC DISTORTION
- FREQUENCY RESPONSE (LINE IN)
- SIGNAL TO NOISE RATIO (LINE IN)
- RATING INPUT LEVEL/IMPEDANC
- line in 800~900mV/47kohms
- OPERATING TEMPERATURE RANGE
- 0 to +40°C (32 to +104 °F)
- POWER CONSUMPTION (RATING CONDITION)
- PHANTOM POWER DISABLE
- via internal jumper
- PHANTOM POWER
- ACCESSORIES INCLUDED
- 1 x 2-phono to 2-phono cable 2m long
1 x 3.5mm to 3.5mm minijack cable 2m long
2 x Unshielded Speaker Cable 5m long
1 x UK C7 figure-8 power cable 1.8 m long
1 x EU C7 figure-8 power cable 1.8 m long
1 x AU C7 figure-8 power cable 1.8 m long
1 x US C7 figure-8 power cable 1.8 m long
1 x Remote Control (Battery included: CR2025 3V Li-Mn)
1 x Rack ears
1 x Ceiling pole and wall brackets
- POWER SUPPLY
- 100~240V Internal Power Supply
- Lifetime return-to-base
- RoHS, WEEE, CE/EMC, CE/LVD, RCM_SDOC, FCC_BT3.0, FCC_BT4.0, CE-RED
- SPARE IR REMOTE CONTROL
- AV-1800 RC
- ORDER PART CODE:
- AV-1800 [EU SAP: 4262711 / US SAP: 12928309]
or AV-1800+CS-1800 bundle [SAP:4363207]
or AV-1800+SP-1800B bundle [SAP:4363208]
or AV-1800+SP-1800 bundle [SAP:4363209]
- Country of Origin